Sealing Ring For Halfshaft Flange

Removing and Installing Sealing Ring For Halfshaft Flange - GT2

Tools










Removing Sealing Ring For Halfshaft Flange







1. Unclip the B-plus cable from the holder -A- (only the right side).
2. Uncouple drive shaft on the transmission side. Unscrew the hexagon head blots -B-.







3. Unscrew the fastening screw between the halfshaft flange and the transmission.
4. Unscrew the halfshaft flange out of the transmission past the drive shaft.
5. Lever out sealing ring using a suitable tool.

Installing Sealing Ring For Halfshaft Flange







1. Fill the space between the dust and sealing lips with grease (e.g. Liqui-Moly) and drive in the sealing ring up to the mounting face with special tool pressure piece No. 9252.







2. Push in the halfshaft flange and tighten the fastening screw. If necessary, hold the halfshaft flange with 2 screws.

Tightening torque: 44 Nm (32 ftlbs.).

3. Fitting the halfshaft flange on drive shaft

Tightening torque: 81 Nm (61 ftlb.).

4. Clip in the B-plus cable in the holder (only the right side).

Tightening Torques