Disassembling and Assembling Transmission Housing - GT2

343737 Disassembling and Assembling Transmission Housing - GT2

Tools











Overview














Note:
^ Parts of the shifting mechanism will fall into the transmission if the bearing screw No. 23 is unscrewed.

Disassembly and Assembly Instructions

Disassembly





1. Remove closure cap. To do this, drill a 3.5 mm hole into the center of the cap, screw in a sheetmetal screw (4.8 x 25) with large washer, and lever the cap out using two screwdrivers.

Assembly





1. Fit selector lever and shift pinion in the correct position. (The driver cross is vertical and the selector lever reaches the flat surface of the housing.)





2. Fit the retainer in the correct position and make sure it is seated properly.

Tightening Torques