Removing and Installing Rear Side Section Flap

Removing And Installing Rear Side Section Flap







Removing and installing rear side section flap













Once the rear side section flap has been removed and installed, the convertible top must be calibrated.

Adjusting the gap dimensions of the rear side section trim

Adjusting the rear side section trim







(Convertible top open and set down.) Insert a plastic spatula under the trim and press it out. The height adjustment is made using the fastening screws -D1- in the flap.

- Set the gap dimension -D- rear side section flap to the side trim panel.
- Set the gap dimension -E- rear side section flap to the side trim panel.
- Set the gap dimension -F- rear side section flap to frame trim panel for the roll-over protection system.

Test and adjustment values







NOTE:
- Illustration of the gap dimensions