Installing Oil Extraction Pump - GT3

Installing oil extraction pump - GT3











Installation overview of the oil extraction pump - GT3
1 Replace seals
2 Put on oil extraction pump
3 Tighten return line





1. Replace seals
The three seals shown must always be replaced. Coat the large O-ring with acid-free grease to facilitate assembly of the oil extraction pump.





2. Put on oil extraction pump
Put on oil extraction pump. When doing this, make sure that the driver and the input shaft of the oil extraction pump are correctly aligned. Tighten the three fastening screws to 13 Nm (10 ft. lbs.).





3. Tighten return line
Tighten return line on the oil extraction pump. Make sure to counter with a wrench when doing this.
Fill in drained oil again. Fill the uncontaminated oil back into the engine through the oil filler opening. Then check the engine oil level.