Removing and Installing Drive Motor For Headlight Beam Adjustment

Removing And Installing Drive Motor For Headlight Beam Adjustment

NOTE: The adjusting screws for lateral and for vertical and lateral adjustment must not be moved during removal or installation of the drive motor (this changes the adjustment travel). Switch for headlight beam adjustment in position "0".

Removal
1. Remove the headlight and open the rear cover. Disconnect the electrical plug connection on the drive motor.
2. Undo the fastening screw and remove the drive motor by turning counter-clockwise (bayonet lock).







3. Swivel the drive motor up, press down the locking tab (arrow) with a small screwdriver and carefully pull out the drive motor (plastic housing).







Installation
1. Press the ball head into the ball socket and secure the drive motor by turning clockwise (bayonet lock).
2. Secure the locking screw and snap in the plug connection.
3. Close cover and install headlight. Carry out function check of headlight beam adjustment.