Installing Selector Support
Installing selector supportNote!
^ Install in reverse order to removal.
1. Insert selector support and connect electrical plug connections.
2. Tighten fastening nuts.
Tightening torque: 10 Nm (7.5 ft. lbs.)
3. Insert support bracket sleeve on the selector lever cable in the support bracket on the selector support. Make sure the two plastic clips engage properly.
4. Push selector lever cable all the way back, shifting the transmission into parking position.
5. Move selector lever to position P.
6. Engage the selector lever cable into the open adjuster and close the adjuster. The locking sleeve on the adjuster must move to the end position automatically.
7. Engage cable nipple in the keylock lever.
8. Insert adjuster on the keylock cable into the support bracket. Make sure the two retaining clips engage properly.
9. Install centre console.
10. Installing selector knob.