Removing and Installing Selector Support

Removing and installing selector support








1 Cable nipple
2 Keylock lever
3 Adjuster
4 Retaining clip
5 Cable sleeve
6 Selector support
7 Locking button A = Close adjuster B = Open adjuster
8 Adjuster (open)
9 Adjuster (closed)
10 Retaining clip
11 Hexagon nut

Removal
1. Remove selector knob.
2. Remove centre console.
3. Move selector lever to position "D".
4. Disengage keylock cable:
Open adjuster (3) by pressing the unlocking button (7).

Press the retaining clip (4) together and carefully pull the adjuster (3) upward out of the support bracket.

Disengage cable nipple (1) on the keylock lever (2).

5. Disengaging selector lever cable:
Slide the locking sleeve of the adjuster forward and turn it clockwise to removal position (8).

Press the retaining clip (10) together and carefully pull the cable upward out of the support bracket.





6. Disconnect plug connection.
7. Unscrew fastening nuts (11).

Installation
Install in reverse order, observing the following points:
1. Tighten fastening nuts (11) to 10 Nm (7.5 ft. lbs.).
2. Fastening selector lever cable:
Press the cable into the support bracket until the retaining clip engages in the housing (10).

Press cable into the open adjuster (8) and close the adjuster (9). The locking sleeve must move to the end position automatically (9).

3. Fastening keylock cable:

Note!
^ Adjust the keylock cable only with the selector knob fitted.

Install selector knob.

Turn ignition key to position "1" (ignition on) and move selector lever to position "D".

Open adjuster (3).

Engage cable nipple (1) on the keylock lever (2).

Press housing for adjuster (3) into the support bracket until the retaining clip (4) engages.

Move selector lever to position "P" and turn ignition key to position "0" (removal position).

Press cable sleeve (5) toward the selector support.

Release cable and press locking button (7) until it engages.

4. Check keylock function:
Turn ignition key to position "1" (ignition on).

Move selector lever from position "P" to "D" and turn ignition key counterclockwise.

The removal position must not be reached.

Release ignition key again and engage selector lever position "P". In this position, it must be possible to remove the ignition key and the locking button must be locked.

5. Remove selector knob once more.





6. Fit rotary valve in correct position and install centre console.
1 Rotary valve
2 Spring
3 Direction of travel