Driver's Airbag Unit

Removing And Installing The Driver's Airbag Unit

Removing driver's airbag unit

1. Remove ignition key.
2. Disconnect the battery and cover terminal or battery.
3. Undo the -fastening screws- (2 ea.) with a socket wrench insert for inside Torx T 30 (at least 50 mm long).






NOTE:
- The self-locking screws must be replaced every time they are undone!
- To do this, undo the retaining bracket of the airbag unit (3 screws) in the steering wheel!

4. Disconnect the electrical plug connection.

WARNING: Danger of injury and damage to property as a result of incorrect handling of airbag units! Please observe the following points:
- The airbag unit must always be deposited so that the airbag opening faces upwards!
- If removed for an extended period, the airbag unit must be kept in a locked place!
- Observe the safety regulations!

Installing driver's airbag unit

1. Tightening torque for fastening screws (2 screws M6 x 16): 10 Nm (7.5 ftlb.)
2. Tightening torque for retaining bracket (3 screws M5 x 20): 5 Nm (3.5 ftlb.)