Installing

1. Install and fasten starter. Fasten B+ lead from the battery and B+ lead from the engine B+ disconnection point to terminal 30 (M8 nut) on the solenoid switch.
2. Fasten terminal 50 lead (M6 nut) to the solenoid switch.

Tightening torque:
M8 hexagon nut 15 Nm (11 ft.lbs)
M6 screw 6.5 Nm (5 ft.lbs)
M10 hexagon-head bolt 46 Nm (34 ft.lbs)

3. Push protective cap over the solenoid switch and engage in the B+ lead.
4. Fasten the sheetmetal holder on the transmission flange lid and engage the plastic holder.
5. Fasten the coolant lines under the automatic transmission and install the cross member.
6. Install the parking brake cable and fasten the cover under the automatic transmission.
7. Connect the battery and perform a function test.