Sealing Ring For Input Shaft

Tools

Item 1 - 3:

Removing Sealing Ring For Input Shaft
1. Remove engine transmission unit and remove the transmission.
2. Remove guide tube for release bearing.
3. Screw puller No. 9629 securely into the sealing ring.







NOTE: The coil spring must be pulled off the input shaft with a wire hook if the spring should jump down when removing the sealing ring.







4. Pull out sealing ring by screwing in the hexagon-head screw.

Installing Sealing Ring For Input Shaft







1. Push assembly sleeve No. 9255 onto the toothing of the input shaft
2. Fill the space between the dust and sealing lips on the sealing ring with grease (e.g Liqui-Moly).







3. Drive in sealing ring with pressure piece No. 9256 as far as the mounting face.
4. Install guide tube and tighten the fastening screws.

Tightening torque: 10 Nm (7.5 ftlb).

NOTE: The guide tube fastening screws are micro-encapsulated, therefore replace screws entirely.

5. Clean teeth of the input shaft and grease with a thin coat of Olista Longtime 3 EP (only as corrosion protection).

Tightening Torques