Removal

Removal

Caution:
PCCB (Porsche Ceramic Composite Brake): Danger of material damage during wheel removal/installation (danger of damage to brake discs)!
^ Use assembly aids (assembly pins) in order to exclude any possibility of heavy contact of the wheel with the brake disc! The assembly aids (2 assembly pins) are located in the luggage compartment!





1. Screw the 2 assembly aids (assembly pins), instead of 2 wheel bolts, into the wheel hub before wheel removal/installation. During removal, first remove the three remaining wheel bolts and remove the wheel carefully, without touching the brake discs.
2. Subsequently (after the wheel is disassembled) remove the 2 assembly aids (assembly pins) again.

Note:
^ In order to gain better access for assembly work, it is beneficial to turn the wheels fully either to the right or the left!

3. Press the electrical lead for the speed sensor/wear indicator out of the holder.
4. Undo the plug coupling for the speed sensor/wear indicator on the wheel carrier.
5. Loosen holder for brake line at wheel carrier.
6. Disengage the electrical lead for the wear indicator from the clips.
7. Set the brake pads back slightly with the piston resetting fixture.
8. Undo the brake caliper on the wheel carrier and hang it in a suitable place in the wheel well (do not open the brake hydraulics!).
9. Take off the brake disc after removing the countersunk screws.