Crankshaft Position Sensor: Service and Repair

Removing And Installing Hall Sender - Engine Installed

WARNING:
- Danger of burns: Parts of the exhaust system can be extremely hot.
- Do not begin work until the exhaust system has cooled down or wear suitable protective gloves:

Removing hall sender

Preliminary work: Remove rear spoiler.

WARNING: Danger of fire: The heat shield should not be bent or deformed. Bent or deformed heat shields must be replaced.

1. Remove heat shield rear bumper.







2. Disconnect the hall sender plug connection.
3. Unscrew hexagon socket head bolt.







4. Remove the hall sender.

Installing hall sender

NOTE: The hexagon socket head bolt is micro-encapsulated and so must always be replaced.

1. Position hall sender, then screw in and tighten the new hexagon socket head bolt.
Tightening torque 10 Nm (7.5 ftlb.)







2. Clip in the plug connection.
3. Install heat shield rear bumper.







4. Install rear spoiler.