Vehicle Hand-Over

Vehicle Hand-over

The PCM2 is converted to delivery mode (low-current mode) in production. As known from other systems (alarm system, instrument cluster, roll-over bar), the PCM2 must be activated with the Porsche System Tester II 9588.
1. Connect and start the Porsche System Tester II 9588 and switch on the ignition.
2. Select the menu item Special functions and press the >> key.
3. Select the menu item Vehicle hand-over and press the >> key.
4. Follow the instructions of the Porsche System Tester II 9588.

Air conditioning
The following versions can be coded:
- Without air conditioning
- With air conditioning

Country-specific tuner settings
The following country-specific tuner settings can be coded:
- Europe.
- North America.
- South America.
- Australia.
- Asia.
- South Africa.
- Japan.

Coding country-specific tuner settings
1. Connect and start the Porsche System Tester II 9588 and switch on the ignition.
2. Select 911 Turbo (996) in the Vehicle type menu and confirm with the >> key.
3. Select PCM2 in the control modules selection and confirm with the >> key
4. Select PCM2 GW in the control modules selection and confirm with the >> key.
5. Select the Coding menu item and press the >> key.
6. Select the menu item Tuner parameters and press the >> key.
7. Take the country-specific code as it appears in the table, enter it in the form and code with the F8 key.

MOST switch
The MOST switch is part of the PCM2. If external MOST control units are present, they will only work if the MOST switch is open.

The following settings can be coded:
- MOST switch open.
- MOST switch closed.

NOTE:
- When the PCM2 is replaced, the coding must be performed in accordance with the vehicle equipment.
- When the Switch closed parameter is set, the switch remains closed even in existing MOST control modules. Communication is then not possible.

Coding PCM2
1. Connect and start the Porsche System Tester II 9588 and switch on the ignition.
2. Select 911 (996) in the Vehicle type menu and confirm with the >> key.
3. Select PCM2 in the control modules selection and confirm with the >> key
4. Select PCM2 GW in the control modules selection and confirm with the >> key.
5. Select Coding in the PCM2 GW function selection and confirm with the >> key.
6. Select PCM2 code in the PCM2 GW coding and confirm with the >> key.
7. Take the PCM2 code from IPAS, enter it in the form and code with the F8 key.

Production mode
If the MOST control module is set to Production mode on, it is in low-current mode. The display remains black, the control module cannot function.
1. Connect and start the Porsche System Tester II 9588 and switch on the ignition.
2. Select 911 Turbo (996) in the Vehicle type menu and confirm with the >> key.
3. Select PCM2 in the control modules selection and confirm with the >> key.
4. Select PCM2 GW in the control modules selection and confirm with the >> key.
5. Select Coding in the PCM2 GW function selection and confirm with the >> key.
6. Select Production mode in the PCM2 GW coding and confirm with the >> key.
7. Select Production mode off menu and code with the F8 key.

The following options can be coded:
- Production mode off
- Production mode on

Control module replacement - PCM2
The PCM2 is supplied in production mode on in new vehicles and as a spare part. Before putting the PCM2 into operation, the Production mode on must be set to Production mode off in the Coding menu when selecting the function of the PCM2-GW, and the vehicle must be locked and secure. Afterwards, PCM2 is functional. The procedure is explained in detail under Production mode.