Installing Sealing Ring For Drive Shaft

Installing sealing ring for drive shaft





1. Push special tool assembly sleeve 9255 onto the toothing of the input shaft.
2. Fill the space between the dust and sealing lips on the sealing ring with grease (e.g. Liqui-Moly).





3. Drive in sealing ring with special tool pressure piece 9256 as far as the mounting face.
4. Install guide tube and tighten the fastening screws.
Tightening torque: 10 Nm (7.5 ft. lbs.).

Note:
^ The guide tube fastening screws are micro-encapsulated, therefore replace screws entirely.

5. Clean teeth of the drive shaft and grease with a thin coat of Olista Longtime 3 EP (only as corrosion protection).