Test Point 46

TEST POINT 46
Airbag Signal Acknowledged

Fault Code 48
This fault is stored in the memory if the airbag control module transmits a signal to the alarm system control module after the airbag has been triggered. This is a triggering log.

Procedure

1. Clear fault memory.

Switch ignition off and then on again.

Check whether the fault appears again.

If the fault reappears, pull off plug II on alarm system control module

Ohmmeter on alarm system control module plug II pin 1 and ground

Ohmmeter display: < 5 ohms

2. Check the entire system for operation.