Test Point 6

Note:
The specified voltage values are reference values.

TEST POINT 6
High Beam

- Engine off

- Parking light off

- High beam off

PST 2 display: 0

- Engine off

- Parking light on

- High beam on

PST 2 display: 1

If 0 is displayed with the high beam on:

1. Check fuse A-1

2. Switch ignition off and pull off plug on the control module

- Switch ignition on

- Switch the high beam on and measure the voltage between plug pin 15 (high beam on signal) and ground.

Voltmeter display: > 10 Volts

If the high beam signal is present at the control module, replace the control module. If the high beam signal is not present at the control module, check for an open circuit in the wire.