Intake Manifold: Service and Repair

Assembly instructions





Assembling intake distributor
Tighten the micro-encapsulated hexagon-head bolts M6 x 16 in the prescribed sequence.
Tightening torque 9.7 Nm (7 ft. lbs.).







Aligning rubber sleeves between distributor pipe and intake distributors.
Line up the rubber sleeves with the markings (arrows) and tighten the inner hose clamps.
Push the distributor pipe between the intake distributors and align so that the dimension "X" is the same on both right and left. Tighten the outer hose clamps.
Secure the support between the throttle body and crankcase.







Fitting vacuum control pipe on the intake distributor
Mount the vacuum control pipe between the fuel pressure regulator and the intake distributor at the left-hand rubber sleeve. Route the vacuum control pipe so that it is tension-free.







Fitting check valve on intake distributor.
The black side of check valve must face rubber sleeve. Lay vacuum hose tension-free.