Condenser Fan: Service and Repair

Removing and installing fan for condenser

Removal
1. Remove front wheel, wheel housing liner and wing support.






2. Detach cooler bracket from the body (1 nut, 2 M8 screws). Unclip ventilation hose and ballast resistor. Undo retaining clips from the cooler and pull off the cooler bracket downwards.






3. Disconnect the electrical plug connection and undo retaining clips from the fan housing. Pull fan housing out of the holder, bending up the ventilation hose on the cooler at the same time.






4. Detach fan motor from the fan housing and remove.

Installation
1. After installation, check whether the fan can rotate freely.
2. Tighten front wheel to the specified torque (130 Nm (96 ft lb.)).