Removing and Installing Air/Oil Separator

Removing and installing air/oil separator

Engine removed




Component view




Designations and notes

Assembly instructions

Sealing the oil pan





Only "Drei Bond" silicone type 1209 should be used as surface seal. After application of surface seal (silicone bead), screw together within five minutes.

Application of silicone bead

1. At the processing nozzle, cut off the first metering step.
2. Apply a uniform bead approximately 1.5 mm wide to the cleaned sealing surface of the oil pan.





3. Place the oil pan in the correct position carefully, so that the sealing bead is not damaged. Screw two studs or centering pins into the corners of the crankcase housing halves as centering aids.