Driver Airbag Unit

Removing and installing driver's airbag unit

Removal
1. Remove ignition key.
2. Disconnect the battery and cover terminal or battery.






3. Undo the fastening screws (2 ea.) with a socket wrench insert for inside Torx T 30 (at least 50 mm long).

NOTE: The self-locking screws must be replaced every time they are undone. To do this, undo the retaining bracket of the airbag unit (4 screws) in the steering wheel.






4. Disconnect the electrical plug connection.

NOTE: The airbag unit must always be deposited so that the airbag opening faces upwards.

If removed for an extended period, the airbag unit must be kept in a locked place. Observe the safety regulations.

Installation

Tightening torque
M6 x 16 screws (2 screws) 10 Nm (7.5 ft lb.)
M5 x 20 retaining bracket screws (4 screws) 5 Nm (3.5 ft lb.)