Procedures

LEGEND
A = Center position mark (arrows)
B = Drivers that engage in the steering wheel
C = Locking (securing against turning), which becomes effective after removal of the steering wheel

NOTE: If the steering wheel was not in place before the steering gear was removed, the position of the contact unit (spiral spring) may no longer be correct. In this event, remove steering wheel and move contact unit to center position. If this is not done, the spiral spring may be damaged.

1. First move contact unit against the end stop.
2. Turn contact unit two revolutions back from the end stop and then continue turning as far as the center position mark [The exact center position is indicated by the two arrows(A)].
3. Turn front wheels to straight-ahead position before installing the steering wheel (steering shaft mounted on steering gear).