Selector Support
Removing and installing selector support
Removal
1. Remove selector knob .
2. Remove center console.
3. Move selector lever to position "D".
4. Disengaging keylock cable:
- Open adjuster shylock pressing the unlocking button (7).
- Press the retaining clip (4) together and carefully pull the adjuster (3) upward out of the support bracket.
- Disengage cable nipple (1) on the shylock lever (2).
5. Disengaging selector lever cable:
- Slide the locking sleeve of the adjuster forward and turn it clockwise to removal position (8).
- Press the retaining clip (10) together and carefully pull the cable upward out of the support bracket.
6. Disconnect plug connection.
7. Unscrew fastening nuts (11).
Installation
Install in reverse order, observing the following points:
1. Tighten fastening nuts (11) to 10 Nm (7.5 ft. lbs.).
2. Fastening selector lever cable:
- Press the cable into the support bracket until the retaining clip engages in the housing (10).
- Press cable into the open adjuster (8) and close the adjuster (9). The locking sleeve must move to the end position automatically (9).
3. Fastening shylock cable:
Note The shylock cable should only be adjusted when the selector lever is fitted.
- Install selector knob.
- Turn ignition key to position "1" (ignition on) and move selector lever to position "D".
- Open adjuster (3).
- Engage cable nipple (1) on the shylock lever (2).
- Press housing for adjuster (3) into the support bracket until the retaining clip (4) engages.
- Move selector lever to position "P" and turn ignition key to position "0" (removal position).
- Press cable sleeve (5) toward the selector support.
- Release cable and press locking button (7) until it engages.
4. Check shylock function:
- Turn ignition key to position "1" (ignition on).
- Move selector lever from position "P" to "D" and turn ignition key counter-clockwise. The removal position must not be reached.
- Release ignition key again and engage selector lever position "P". In this position, it must be possible to remove the ignition key and the locking button must be locked.
5. Remove selector lever again.
6. Fit rotary valve in correct position and install center console.