Replacing Cylinder Head Cover Gasket
Replacing cylinder head cover gasket1. Remove cylinder head cover.
2. Remove seals from the cylinder head cover (1 cover gasket and 6 recess seals) -32- and replace them.
Note: The seals on the ignition coil slots have a twist lock. These must be inserted into the corresponding cut-out on the cylinder head cover.
3. Replace all seals of the cylinder head cover (1 cover gasket and 6 recess seals) -32- and fit them at the correct position in the inverted cylinder head cover. The seals have twist locks and must be inserted into the corresponding cut-outs of the cylinder head cover.
4. Press M6 fastening screws with spacer sleeve -3- into the cylinder head cover.
Note: When fitting the cylinder head cover, ensure that the seals on the cylinder head cover do not fall out or slip out of place.
5. Install cylinder head cover.