Replacing Cylinder-Head Cover Gasket

Replacing cylinder-head cover gasket

Replacing cylinder-head cover gasket
1. Remove cylinder head cover.

Overview Of Cylinder Head:

2. Remove seals from the cylinder head cover (1 cover seal and 6 slot seals) -32- and replace them.

Note: The seals on the ignition coil slots have a twist lock. These must be inserted into the corresponding cut-out on the cylinder head cover.

3. Replace all seals on the cylinder head cover (1 cover seal and 6 slot seals) -32- and fit them at the correct position in the inverted cylinder head cover. The seals have twist locks and must be inserted into the corresponding cut-out on the cylinder head cover.
4. Press M6 fastening screws -3- into the cylinder-head cover gasket using a spacer sleeve.

Note: When fitting the cylinder head cover, ensure that the seals on the cylinder head cover do not fall out or slip out of place.

5. Install cylinder head cover.