Removing and Installing Sealing Ring For Output Shaft 2

Removing and installing sealing ring for output shaft

Tools





Preliminary work for sealing ring for output shaft
1. Remove transfer box.

Removing sealing ring for output shaft

Overview Of Sealing Ring:

1. Screw countersunk head bolt and bolt adapter from slide hammer kit NR.168 into sealing ring -direction of arrow-.





2. Screw on slide hammer from slide hammer kit NR.168 and remove sealing ring-Bild-.

Installing sealing ring for output shaft

Overview Of Sealing Ring:

1. Push special tool protective sleeve T10186-arrow- onto output shaft.
2. Push on sealing ring.





3. Remove special tool protective sleeve T10186 and drive in sealing ring flush using special tool pressure piece T10180-arrow- arrow.

Subsequent work

Reworking sealing ring for output shaft
1. Install transfer box.