Transverse Interlock

Fault Code 2054

Transverse lock control module

Diagnostic conditions
- Ignition on
- Internal control module function test

Possible cause of fault
- To localise the fault, read out the fault memory for the transverse lock control module (Please read out fault memory)
- No message from transverse lock control module on CAN drive (no signal/communication)

Affected pins
Transfer box control module plug:
- Pin 11 CAN drive (low)
- Pin 42 CAN drive (high)

Diagnosis/troubleshooting VG 0101

NOTE: If there is no incoming signal/message via the CAN drive using several control modules, the CAN drive must be checked for open or short circuits. Refer to Checking instructions/CAN data bus.

Work Instruction 1 - 2: