Steering Angle Sensor: Service and Repair

Removing and installing steering angle sensor
General information





The steering angle sensor is integrated into the -steering column switch-.
The steering angle is recorded in the contact unit for airbags (spiral spring) -C-. The data determined is sent from the electronic unit -E- via the drive CAN bus to various systems (e.g., PSM, corner-sensitive headlight) for further processing. The steering column switch must be removed in order to replace the steering angle sensor.





If faults have been diagnosed on the steering angle sensor, the steering column switch must be disassembled into the components -A, B, C, D, E-.
^ It is only permissible to replace the steering angle sensor in combination of components, contact unit for airbag -C- (spiral spring) and electronic unit -E-.

Replacing the steering angle sensor
1. In order to replace the steering angle sensor, the components contact unit for airbag -C- and the electronic unit -E- must be replaced
2. Once installed, the steering angle sensor must be calibrated with the Porsche System Tester PSM Go to Page 230 'Initialising and calibrating steering angle sensor'.