Unnecessary DME 7.1.1 Control Module Replacement

Unnecessary DME 7.1.1 control module replacement

NOTE:
- The following list contains P codes for which the DME 7.1.1 control module can be ruled out as a possible cause of damage.
- This means that in these cases, replacing a DME control module is not permitted. The fault source much be searched for according to the instructions described in this manual. See the chapter "Possible fault causes" in the Main Chapter "Introduction".
- Again, we would like to emphasize that defective DME control modules are extremely rare. Replacing a DME control module should only be the last resort after all other fault causes have been ruled out.

Overview table of P-codes for which the DME control module cannot be the cause