Removing the DME Control Unit

Removing And Installing DME Control Unit







NOTE:
- If the DME control unit is replaced, it must be programmed using the Porsche System Tester. This is to adapt the DME control unit to the vehicle, the national variant and the equipment. The DME control unit is located in the radiator tank near the right fender.
- If possible, before the DME control unit is removed and replaced, a read-out of the vehicle data should be obtained from the Porsche System Tester.
- Symbol for the TAB key = ->|.
- Instructions for the Porsche System Tester have a higher priority and are to be followed where descriptions deviate. Deviations may occur with later software versions.

Removing DME control unit

WARNING:
- Risk of short circuit
- Before removing the control unit, switch off the ignition.

NOTE: Unscrew the two fastening screws for the cowl panel cover and lift up the cover in this area.

1. Push the two retaining clips aside -arrow- and remove control unit to the front.







2. Pull out detent of both plugs in the -direction of arrow- and pull the plugs off.