Suspension Control Module: Service and Repair

Removing and installing control unit for off-road stabilizer

Removing control unit for off-road stabilizer

Information:
^ The control unit for the off road stabilizer is located in the luggage compartment under the load space floor beside the collapsible spare wheel.





Overview of control unit for off-road stabilizer

1. Open luggage compartment lid and raise load space floor.
2. Release plug -1- and remove from control unit -Arrows a-.





Pull plug off the control unit.

3. Release plug -2- and remove from control unit -Arrows a-.
4. Remove control unit from the plastic mount.

Installing control unit for off-road stabilizer

1. Insert the control unit in the plastic mount.
2. Insert plug -2- into the control unit until it clicks into place.





Insert plug into control unit

3. Insert plug -1- into the control unit until it clicks into place.

Information:
^ If a new control unit has been installed for the off road stabilizer, continue with "Coding" section.

Coding control unit for off-road stabilizer

Information:
^ The Porsche System Tester instructions take precedence and in the event of a discrepancy these are the instructions that must be followed. Deviations may occur with later software versions.

^ The procedure described here has been structured in general terms; different text or additions may appear in the Porsche System Tester.

1. Connect the Porsche System Tester to the vehicle and start the System Tester. Switch on ignition.
2. Select ORS control unit >>.
3. Select "Coding" >>.
4. Select Porsche version and code with the F8 key.
5. Quit the menu using <<.
6. Read out fault memory.