Removing and Installing Sensor For Body
Removing and installing sensor for bodyPreliminary work
Note:
These instructions for removal and installation describe all the sensors for the body (two sensors at the front, one sensor at the rear).
Installation position at front: Position 8, under the left and right wings.
Installation position at rear: Position 8, under the boot floor plate on the right (sensor can be accessed from the interior!).
Front sensor
1. Lift the vehicle.
2. Remove wheel housing liner.
Rear sensor
Note:
For removing and installing the rear sensor, it is not necessary to lift the vehicle.
The rear sensor can be accessed from the interior.
1. Remove boot floor plate (center part) and remove only the right side cover.
Removal
Front sensor
1. First push together the sensor connector -arrow- firmly (makes removal easier!). Lift connector lock and then remove connector!
2. Loosen screw of holder and remove sensor.
Rear sensor
1. First push together the sensor connector -arrow- firmly (makes removal easier!). Lift connector lock and then remove connector!
2. Loosen nut of holder and remove sensor.
Installing
Front sensor
1. Insert sensor with holder in the correct position -arrow- and tighten the fastening screw.
2. Plug in connector. Pay attention to correct line routing.
Rear sensor
1. Insert sensor with holder in the correct position -arrow- and tighten the fastening nut.
2. Plug in connector. Pay attention to correct line routing.
Subsequent work
Front sensor
1. Install wheel housing liner.
Rear sensor
2. Fit right side cover and install the boot floor plate (center part).