Fluid Pan: Service and Repair

Removing and installing ATF pan
Removing ATF pan
1. Remove engine guard.

Caution:
^ Danger of scalding with hot ATF.
^ Wear personal protective equipment (e.g. safety goggles, gloves).





2. Place collection pan under the transmission. Unscrew oil drain plug -B- and drain ATF.
3. Screw in oil drain plug -B- with new sealing ring.
Tightening torque: 28 Nm (21 ft. lbs.)





4. Unscrew screws on the ATF pan and remove pan.

Installing ATF pan

Note:
^ Make sure that the seal has been positioned correctly on the bead of the oil pan edge.

1. Place new seal on the ATF pan.





2. Check position of the magnets in the oil pan.





3. Position ATF pan and tighten screws.
Tightening torque: 10 Nm (7.5 ft. lbs.)





4. Unscrew oil inspection plug -A- and fill ATF until slight emission is visible.
5. Screw in oil inspection plug again -A- with new sealing ring.
Tightening torque: 70 Nm (52 ft. lbs.)
6. Check ATF.
7. Install engine guard.





Tightening torques