Tire Pressure Sensor: Service and Repair
Removing and installing wheel electronicsRemoving wheel electronics
General information on wheel electronics:
The tire pressure monitoring system is designed to constantly monitor the tire pressure during driving and when standing. One set of electronics -A- per tire is mounted in the rim well base. These measure tire pressure and temperature at regular intervals and transfer the values to a central control unit via a high-frequency route. The control unit evaluates the information and transfers the data to the instrument cluster if required. In this way, the driver is warned and informed if the tire pressure has to be corrected.
There are two versions of the wheel electronics -A-. In the case of the Cayenne, versions with amplified transmitting power are used. These transmit in the high frequency range:
^ 433 MHz or 315 MHz.
The following points can be used as distinguishing characteristics:
^ The labeling, 433 MHz or 315 MHz
^ The part number
^ 4 stars on left and right of the slot (wheel electronics with amplified transmitting power only)
^ And/or the color (dark grey 433 MHz; light grey 315 MHz).
Removing wheel electronics
Note:
^ For vehicles with a tire pressure monitoring system, the valve and wheel electronics are only replaced in exceptional cases! The following points can make replacement necessary!
Valve complete with screw -1 bis 7- has to be replaced if:
^ The wheel electronics are removed.
^ The self-locking -1- fastening screw is loose.
^ The bead seat sealing ring -6- is porous or damaged.
^ The valve body -7- is bent.
^ The union nut -4- is loose.
The wheel electronics -A- must be replaced if:
^ The housing is visibly deformed.
^ The filter surface (square, porous section on back of wheel electronics) is so badly soiled that it can no longer be cleaned by wiping.
^ Tyre sealant tire sealing liquid) has been used.
^ The service life of the battery has expired.
^ There is a fault within the wheel electronics.
After removal of the tire the wheel electronics -A- can be seen at the valve in the outer rim well base.
1. Release wheel electronics from valve using a Torx socket screwdriver T 20 (if necessary, counter with a suitable assembly pin, e.g. steel pin 0 approximately 1.8 mm in bore at valve foot) and remove.
2. Then unscrew union nut and remove valve.