S9.3 - S - Stopper

S 9.3 S - Stopper

S 9.3.1 Standox(R) PE Soft Stopper
S 9.3.1.1 Processing

S 9.3.1 Standox(R) PE Soft Stopper







WARNING: -> 2 "Safety regulations" and read the product-specific safety instructions on the container labels.

DESCRIPTION:
- Universal polyester coarse and fine stopper

Properties:
- Can also be used as a stain stopper
- Good drawing properties
- High creep strength
- Excellent adhesion
- Easy to sand

Base surfaces:
- Hardened paintwork, sanded
- Sheet steel, aluminum and UP-GF, sanded
- Hardened Standox(R) 2K Universal Filler or Standox(R) 2K Nonstop Primer Filler, sanded
- Galvanized sheetmetal
- Please note base surface pre-treatment instructions:
-> S 5.1
-> S 9.2.2

NOTE:
- Raw material base: Unsaturated polyester resin
- Flash point: 32° C/89.6° F
- Spec. weight: 1.83 g/cm3
- Solid content: 85.8% weight/71.1% vol.
- Storage: Polyester materials have a limited shelf life; always store in a cool place. Application within 12 months guarantees perfect results.
- Do not use on acid primer, Standohyd(R) 1K Primer Surfacer, TPA paint finishes and elastic-rendered old paint finishes.
- Do not apply below 5° C
- Mix 2-3% Standox(R) Hardener Paste red and stopper well. Try not to overdose as this can result in discoloration of the final paint finish.
- lean equipment after use with cleaning thinner

VOC value:
- 259 g/l

WARNING:
- Hardener pastes contain organic peroxide and have a corrosive effect. Wipe off splashes on the skin immediately and wash with soap and water.
- Rinse out splashes in the eyes with plenty of watery 2% sodium carbonate solution or plenty of water. Consult a doctor immediately.

S 9.3.1.1 Processing







S9.4 - G - Primer