Procedures

610519 Removing And Installing Latch At Front

Preliminary work
1. Remove interior light.
2. Remove operator control unit for garage door opener.

Removing latch at front

Removing front lock

Installation Position Of Front Lock:

1. Release the two fastening screws -1- and pull the front lock -2- down and off -arrow- from the windscreen frame.

Removing Front Lock:

2. Push up the electric connecting lines for the interior light and the control unit for garage door opener through the assembly openings on the front lock.
3. Pull off connector -1- on microswitch for roof -2- -arrow-.

Installing latch at front

Installing front lock
1. Push on connector -1- for roof microswitch -2- -arrow-.
2. Push the electric connecting lines for the interior light and the garage door opener control unit from above through the assembly openings on the front lock.

NOTE: When fitting the front lock make sure the electric connecting lines are laid so that they are not trapped.

3. Mount front lock -1- from below -arrow- on windscreen frame.

Installing Front Lock:

4. Tighten front lock with the two fastening screws -2-.
Tightening torque 7.5 ftlb.

Subsequent work
1. Install operator control unit for garage door opener.
2. Install interior light.