Removing and Installing Sealing Ring For Selector Shaft

WM 373319 Removing and installing sealing ring for selector shaft





Preliminary work

Preliminary work
1. Remove engine-compartment lid.
2. Fix the engine in the installation position using safety device 10-222 A at the engine lifting bracket.





Safety device

3. Raise the vehicle at the prescribed jacking points.
4. Remove support plate.
5. Remove multi-functional switch.

Removing sealing ring for selector shaft

Removing sealing ring for selector shaft
1. Disengage push rod from ball head on selector lever.





Push rod

2. Drive out roll pin and pull selector lever off selector shaft.





Driving out roll pin

3. Pierce sealing ring with a small screwdriver and lever it out.





Levering out sealing ring

Installing sealing ring for selector shaft

Installing sealing ring for selector shaft
1. Thinly coat sealing lip and outer circumference of sealing ring with Vaseline.

With open side of sealing ring facing transmission, tap sealing ring as far as it will go into the transmission using a mandrel 3385.





Tapping in sealing ring

2. Attach selector lever to selector shaft and tap in roll pin.





Tapping in roll pin

3. Engage push rod in ball head on selector lever.





Push rod

Subsequent work

Subsequent work
1. Install multi-functional switch.
2. Install support plate.
3. Lower the vehicle.
4. Remove safety device 10-222 A.





Safety device

5. Install the engine-compartment lid.