Removing and Installing Sealing Ring For Input Shaft

WM 355019 Removing and installing sealing ring for input shaft





Preliminary work

Preliminary work
1. Remove transmission.
2. Remove guide sleeve.

Removing sealing ring for input shaft

Removing sealing ring for drive shaft
1. Press guide sleeve on sufficiently and drive sealing ring out of the guide sleeve using a punch.





Removing sealing ring

Installing sealing ring for input shaft

Installing sealing ring for drive shaft - 6-speed transmission
1. Place new sealing ring on side of pressure piece P 9743 with a cut-out.





Positioning sealing ring

2. Tap sealing ring into the guide sleeve using a rubber hammer.





Tapping in sealing ring

Subsequent work

Subsequent work
1. Install guide sleeve.
2. Install transmission.