Camshaft Position Sensor: Service and Repair

Removing And Installing Hall Sender

Tools

Tools:

Preliminary work







1. Pull the design cover straight up and off.
2. Remove engine compartment covers at left and centre plenum panel.

Information

Component overview

Component Overview:

Removing hall sender







1. Open both plastic clips of the rear valve cover wiring harness and lay the wiring harness aside -1-.

NOTE: Mark hall sender cable plugs according to position of exhaust and inlet camshafts.







2. Pull off cable plug on camshaft hall senders -top section of figure-. To do this, use an angled piece of wire to pull off the cable plug. Release the cable plugs on the inlet -2- and outlet -3- camshaft hall senders -arrows D- and pull them off -arrows E-.







3. Unscrew the two fastening nuts for the engine wire harness on the top chain case lid -1- and push the engine wire harness to the plenum panel.







4. Unscrew the fastening screws for the hall senders -2- and carefully pull out the hall senders.

Installing hall sender

NOTE: Check the sealing rings on the hall senders and replace them if necessary or replace the hall sender.

1. Place hall sender in installation position and insert into the top chain case. Screw in fastening screw hand-tight. Tighten fastening screw. Tightening torque 7.5 ft.lb.







2. Fit engine wire harness to top chain case lid -1-.
3. Connect cable plugs for camshaft hall senders to the relevant hall senders.







4. Insert top wiring harness into the two plastic clips -1- and close clips.

Subsequent work
1. Fit engine compartment covers.







2. Press the design cover on to the ball heads.