Tow Sensor: Service and Repair

Removing And Installing Tilt Sensor Control Unit

Preliminary work

1. Remove the side-panel lining at rear right.

Removing tilt sensor control unit







NOTE: The tilt sensor is integrated into the tilt control unit and cannot be separately replaced.

1. Switch off ignition and remove ignition key.







2. Undo the two fastening screws -arrows A- and remove tilt sensor.







3. Press detent on plug -arrow a- and pull off plug.

Installing tilt sensor control unit







1. Push in electric plug of control unit until it is felt to engage.







2. Position control unit on support and screw it down with fastening screws -arrows B-.

Subsequent work

1. Install the side-panel lining at rear right.