Removing and Installing Upper Part of Rear Lock

Removing And Installing Upper Part Of Rear Lock







Removing upper part of rear lock

Removing rear lock upper part

1. Remove trim panel for rear lid.












2. Disengage actuating rod.
2.1. Pull control rod -1- out of lid release -Arrow A-.












3. Remove upper part of lock.
3.1. Undo fastening screws -2, 3-.
3.2. Pull upper part of lock -4- out of the assembly opening -Arrow B- until there is access to the electrical plug connection.
3.3. Press in locking tabs of plug -5- -Arrows C- and pull off plug.
3.4. Remove upper part of lock.

Installing upper part of rear lock

Installing rear lock upper part












1. Install upper part of lock
1.1. Push electric connector -5- onto lock upper part -4- -Arrow A-.
1.2. Insert upper part of lock into the assembly opening (-Arrow B-).
1.3. Screw in fastening screws -2, 3- and tighten to the specified tightening torque. Tightening torque 19 ftlb. +/- 2.0 ftlb.












2. Engage actuating rod.
2.1 Clip control rod -1- into the lid release -Arrow C-.

3. Check adjustment of rear lid and if necessary adjust lock lower part accordingly.
4. Remove trim panel for rear lid.