Removing and Installing Motor For Sun Blind Roof Assembly (Panoramic Roof)

Removing And Installing Motor For Sun Blind Roof Assembly (panoramic Roof)

Preliminary work

1. Removing headliner.
2. Remove ignition key.

Removing motor for sun blind roof assembly (panoramic roof)












1. Release plug connection -Arrow A- and disconnect it -Arrows B-.
2. Remove line from guides -Arrows C-.







3. Undo fastening screws -Arrows 1- and remove motor.

Installing motor for sun blind roof assembly (panoramic roof)

NOTE:
- Before installing motor, check the drive shafts for wear and abrasion.
- After installation of the motor, the limit stop for the roof assembly must be re-initialized in the control unit.







1. Insert motor -Arrow A- and engage drive pinion -a- by turning back and forth -Arrows B- in the drive shaft -b-.
2. Screw down motor with fastening screws -Arrows 1-. Tightening torque 3 ftlb. If necessary, align the cable carrier to the threaded bores -c- by turning back and forth -Arrows C-.







3. Press line into guides -Arrows A-.
4. Push plug connection together -Arrows B- until the locking lug -Arrow C- is felt to engage.
5. Initialize limit stop of motor for roof assembly in the control unit.

Subsequent work

1. Install headliner.