Mobile Roofs: Checking Operation - II
Mobile Roofs: Checking Operation
Teaching control unit
Teaching the panorama roof the limit positions
WARNING: Danger of injury. Risk of material damage.
- Do not reach into the moving area of the mechanism when opening and closing the roof assembly.
- Anti-crushing protection is deactivated in emergency operation mode.
- If there is danger, release the rotary switch immediately or activate it in the opposite direction, or switch off the ignition.
- Never open the roof assembly without having initialized the limit position of the motors. Danger of collision for the two rear roof segments.
NOTE:
- When the maximum duration of operation (> 40 seconds) is exceeded, the fault code 0409 (Rotary switch emergency button signal is permanently displayed) can be stored in the control unit.
- Initialization must be completed fully as otherwise the roof cannot be operated electrically.
- If initialization is interrupted or terminated, the entire procedure must be repeated.
1. Switch on ignition and turn rotary switch to the position "Close roof fully". Wait until the roof remains in any position.
2. Keep the rotary switch pressed -arrow- until the sun blind and the roof are completed closed.
3. Relieve the seals from strain by briefly opening and then closing the roof again.
4. Read out the fault memory with the Porsche System Tester and remedy any faults.
Checking operation
Checking sliding roof/panorama roof
1. By operating the control switch, return to original tilting, opening and closing positions. During operation, check for malfunctions and noises.
2. In vehicles with a sunroof: Fully open and close sliding roof lining by hand. During operation, check for noises and stiffness.