Mobile roofs: Checking Operation - I

Mobile Roofs: Checking Operation

Checking sliding roof

1. By operating the control switch, return to original tilting, opening and closing positions. During operation, check for malfunctions and noises.
2. Fully open and close sliding roof lining by hand. During operation, check for noise and stiffness.

Teaching the panorama roof the limit position

NOTE:
- When the maximum duration of operation (> 40 s) is exceeded, the fault code 0409 can be stored in the control module.
- Initialization must be completed fully as otherwise the roof cannot be operated electrically.
- If initialization is interrupted or terminated, the entire procedure must be repeated.

1. Turn on ignition and turn rotary switch to the position "Close roof fully".
2. Wait until the roof remains in any position.
3. Keep the rotary switch pressed until the sun blind and the roof are completed closed.
4. Relieve the seals from strain by briefly opening and then closing the roof again.
5. Read out the fault memory with the Porsche System Tester and remedy any faults.