Operation CHARM: Car repair manuals for everyone.

Removing and Installing Rear Adjustment Fitting



Removing And Installing Rear Adjustment Fitting

Removing rear adjustment fitting and support plate

Removing rear adjustment fitting







WARNING: The support plate with threaded parts will be damaged in the event of impact with seat belt buckled.

- Damage to the support plate can lead to impairment in functional capability of the restraint system and personal injury as a consequence.
- When replacing the safety belt following accident damage, the support plate of the adjustment fitting and the threaded parts must also be replaced for safety reasons
.

1. Remove C-pillar trim.







2. Position adjustment fitting so that the upper fastening screw is accessible.
3. Unscrew fastening screw -1-.
4. Fold adjustment fitting inwards -Arrow A- and remove upwards -Arrow B-.

Removing support plate for rear adjustment fitting







1. Unscrew fastening screw -1- and remove support plate.

Installing rear adjustment fitting and support plate

Installing support plate for rear adjustment fitting







NOTE: For safety reasons, the fastening screw -1- for the adjustment fitting support plate must be replaced after removal.

1. Insert rear support plate. Ensure that the tabs -A- lie inside the spacer sleeves.
2. Screw in the fastening screw -1- so that the top of the support plate can still just be moved.

Installing rear adjustment fitting

ATTENTION: Installation of the adjustment fitting

- During installation, the adjustment fitting can get pressed upwards by the reset spring, thereby causing injury.
- When installing the adjustment fitting, please take care to keep your hands and fingers clear of the danger area.
- Wear personal protective gear.







NOTE: For safety reasons, the fastening screw -1- for the adjustment fitting must be replaced after removal.












1. Engage the adjustment fitting on the support plate at the bottom -Arrow A- and fold inwards at the top -Arrow B-.
2. Screw down support plate and adjustment fitting with the fastening screws -1- top and bottom. Tightening torque 3.5 ftlb.
3. Install C-pillar trim.