Installing Main Wiring Harness - Engine Compartment In Center

Removing And Installing Main Wiring Harness

Installing main wiring harness

Overview







Installing main wiring harness - engine compartment in centre







1. Push line through from passenger compartment to engine compartment -Arrow A- until rubber sleeve is felt to engage in firewall -B-.
2. Place line in installation position -Arrow C- and close clip -Arrow D- until locking tabs are felt to engage.







NOTE: Before fastening the line to the brake booster, the pressure sensor connector must be connected due to the restricted access.

3. Push connector (brake assist system) onto pressure sensor until locking tab is felt to engage.
4. Turn the line in front of the brake master cylinder to the right and place in the installation position.







5. Place line in the holders -Arrows A- and close them -Arrows B- until locking tabs are felt to engage.
6. Place line in installation position -Arrow C- and close clips -Arrows D- until locking tabs are felt to engage.







7. Push connector onto switch-over valve for run-on pump -Arrow A- until locking tab -B- is felt to engage.







8. Push connector onto distance sensor (brake assist system) -Arrow A- until locking tab -B- is felt to engage.







9. Push connector onto brake assist system -Arrow A- until locking ab -B- is felt to engage.







10. Place line in installation position -Arrow A- and close clip -Arrow B- until locking tab is felt to engage.
11. Fit ground strap together with twist lock -a- on the threaded bolt -Arrow C- and secure with fastening nut -1-. Tightening torque 6.5 ftlb.

Install front left plenum panel.

Install wiper motor.

Remove left and rear engine compartment covers.