Procedures

280419 Removing and Installing Ignition Switch

Tools

Tools:

Removing ignition switch

Installation Position:

Removing Detachable Cover:

1. Carefully lift up rubber sleeve on the ignition switch using a plastic spatula, for example, and remove it.

Unscrewing Union Nut From Ignition Switch:

2. Turn union nut using a narrow plastic spatula, for example, or using the special wrench T10152 tool and unscrew the ring from the ignition switch.
3. Press ignition switch inwards and remove towards the bottom.

Releasing And Pulling Off Electric Plug:

4. Release electric plug -a- and pull it off the ignition switch.

Installing ignition switch

Connecting Electric Plug:

1. Connect plug on ignition switch until it clicks into place. Connecting electric plug

Turning Union Nut On Ignition Switch:

2. Position ignition switch in the instrument panel from below. Position union nut, re-adjust switch and tighten union nut using wrench T10152 Tightening torque 1.1 ftlb..
3. Place cover in position and slide it over the ignition switch, paying attention to the fitted shape.

Information

Emergency operation of the ignition key lock

NOTE: In the event of insufficient or non-existent battery positive voltage, the ignition key can be removed using the emergency operation.

1. Lever out the small cover, at the top right next to the ignition key, at the ignition switch using a screwdriver.
2. Then, push a pen, for example, into the opening next to the key, turn the ignition key to position 0 and pull it out.