Removing and Installing Long Halfshaft Flange
Removing and installing long halfshaft flangeTools
Preliminary work
1. Raise the vehicle at the prescribed jacking points.
2. Remove left rear wheel.
3. Remove left drive shaft.
Removing long halfshaft flange
1. Unscrew fastening screw for the coolant hose holder on the mounting saddle.
2. Unscrew fastening screws for the mounting saddle using socket wrench 9330.
3. Carefully pull halfshaft flange out of transmission.
Installing long halfshaft flange
1. Check halfshaft flange for burrs and sharp edges on the transmission end of the shaft and deburr if necessary.
Note: To avoid damaging the sealing ring in the transmission, the halfshaft flange must be guided carefully into position by hand.
2. Carefully insert halfshaft flange into the transmission.
3. Screw in and tighten fastening screws for the mounting saddle using socket wrench 9330.
4. Screw in and tighten fastening screw for the coolant hose holder on the mounting saddle.
Subsequent work
1. Install left drive shaft.
2. Mount left rear wheel.
3. Lower the vehicle.