Removing and Installing Sealing Ring For Cardan Flange
Removing and installing sealing ring for cardan flangeTools
Preliminary work
1. Raise the vehicle at the specified jacking points.
2. Remove underbody panel.
3. Remove cardan shaft.
4. Remove cardan flange.
5. Place oil collection pan under the transmission.
Removing sealing ring for cardan flange
1. Remove circlip.
2. Remove washer.
3. Use a suitable tool, e.g. a sharp punch, to make a hole in the sealing ring.
4. Screw sheet metal screw approximately 1 cm into the sealing ring sheet metal screw
5. Knock out sealing ring on screw using slide hammer kit NR. 1 68.
Removing sealing ring for cardan flange
1. Lever out sealing ring with hook VW 681.
Installing sealing ring for cardan flange
1. Fill the space between the dust and sealing lips on the new sealing ring with grease, e.g. Liqui-Moly.
2. Drive sealing ring into the transmission using pressure piece 9671.
3. Fit washer.
4. Fit circlip.
Installing sealing ring for cardan flange
1. Fill the space between the dust and sealing lips on the new sealing ring with grease, e.g. Liqui-Moly.
2. Drive sealing ring into the transmission using pressure piece P 9668.
Subsequent work
1. Install cardan flange.
2. Install cardan shaft.
3. Check transmission oil and top up if necessary.
4. Fit underbody panels.
5. Lower the vehicle.
Subsequent work
1. Install cardan flange.
2. Install cardan shaft
3. Check and if necessary, top up the ATF.
4. Fit underbody panels.
5. Lower the vehicle.