Removing and Installing Latch at Front

610519 Removing And Installing Latch At Front






Preliminary work
1. Remove interior light.
2. Remove operator control unit for garage door opener.

Removing latch at front






1. Release the two fastening screws -1- and pull the front lock -2- down and off -arrow- from the windscreen frame.






2. Push up the electric connecting lines for the interior light and the control units for garage door opener through the assembly openings on the front lock.
3. Release connector -1- -Arrow A- and remove from roof microswitch -2- -Arrow B-.






Installing latch at front

Installing front lock
1. Push on connector -1- for roof microswitch -2- -arrow- until it is heard to engage.






2. Push the electric connecting lines for the interior light and the garage door opener control unit from above through the assembly openings on the front lock.

NOTE: When fitting the front lock make sure the electric connecting lines are laid so that they are not trapped.

3. Mount front lock -1- from below -arrow- on windscreen frame.






4. Tighten front lock with the two fastening screws -2-. Tightening torque: 7.5 ftlb.

Subsequent work
1. Install operator control unit for garage door opener.
2. Install interior light.