Removing and Installing Right Halfshaft Flange

WM 392519 Removing and installing right halfshaft flange





Preliminary work

Preliminary work
1. Raise the vehicle at the prescribed jacking points.
2. Remove the underbody panel.

Removing halfshaft flange

Removing halfshaft flange
1. Detach coolant lines on the transmission.





Note
Protect drive shafts against mechanical damage (e.g. with a rubber hose which has been cut open).

2. Remove drive shaft on transmission side. To do this, unscrew the six hexagon socket head bolts joining the drive shaft and halfshaft flange.





3. Lever out halfshaft flange.





Installing halfshaft flange

Installing halfshaft flange
1. Insert halfshaft flange fully into the transmission.
2. Fit drive shaft on transmission side. To do this, screw in the six Allen screws joining drive shaft and transmission flange and tighten screws.








3. Engage coolant lines on the transmission.





Subsequent work

Subsequent work
1. Fit the underbody panel.
2. Lower the vehicle.